Filter
Top Products
Installation Instructions
21
Unpack the components from inside the grill and oven: Check that the
following parts are present.
Grill pan and grid Grill pan handle
Pan supports (2) Oven shelves (2)
Enamelled discs (4) Aluminium burner bodies (4)
Literature Battery 1.5V
Four skid feet are fitted which can be adjusted up or down to level the
cooker.
Caution: Some soft floor coverings may get damaged if the cooker is not
moved carefully.
The cooker must be fitted with a stability device firmly secured to the
fabric of the building. One of the holes in the rear panel can be used to
engage a stability bracket.
The bracket must be
fitted to the wall behind the
cooker. The diagram is a
guide to the correct height
at which the bracket should
be from the floor.
The cooker is designed to match the depth of standard 600mm worktops.
An adaptor backplate should, therefore, be fitted within the shaded area
shown to allow the cooker to be pushed fully to the wall. If a forward
facing backplate is used, it must be chased into the wall.
Connection to the cooker should be made with an approved
appliance flexible connection to BS 669. Hoses connected to the L.P.G.
models should be suitable for L.P.G. and capable of withstanding
50mbar pressure. A length of 0.9 to 1.25m is recommended. The length
of hose chosen should be such that when the cooker is in situ, the hose
does not touch the floor.
The temperature rise of areas at the rear of the cooker that are likely to
come in contact with the flexible hose do not exceed 70˚C.
Unpacking the
Cooker
Levelling
Stability Bracket
Connecting To
The Gas Supply
155mm
Floor to bracket.
250
250
550
680
250
680
250
500