Filter
Top Products
9
Electrical Connection
Connecting the supply cord to the electrical mains:
The hob must be connected to the mains by a double pole
mains switch, which must have a minimum 0f 3mm space
between the contacts, correctly fused with a capacity
appropriate to that shown on the hob Rating Plate. All
electrical wiring from the consumer unit to the appliance, via
the switched double pole cooker outlet, must be of an
acceptable type and current rating as above.
The supply cord should conform to BS6004 conductor size
4mm
2
, must be positioned so that no part of it reaches a
temperature of 50°C above room temperature. The electrical
installation must comply with the IEE Regulations, Building
Regulation & local By-Laws.
Before making the connection, make sure that:
• the limiter switch (fuse) and the residual wiring can support
the appliance load (see the rating plate).
• the mains system is properly earthed in compliance with
current regulations and provisions.
• there is easy access to the socket or the double pole
switch after the appliance is installed.
IMPORTANT:
If the hob is installed above a built-in oven, the electrical
connection for the hob must be independent of that for the
oven, both for safety reasons and to facilitate the removal of
the oven for maintenance, repair etc.
Voltage and frequency of power supply:
240V~ 50/60Hz 5600W
Supply cable installation
The electrcic hobs are supplied without cable. Use a cable:
H05 VV-F 3x2.5mm
2
• Open the terminal box by removing the "V" screw and
taking off the cover.
• The wires in the mains lead are coloured in accordance
with the following code:
Green & Yellow - Earth “E”
Blue - Neutral “N”
Brown - Live “L”
Connect the wires in accordance with the following
diagram
32154
NL
•Fix the cable in place with the "F" cable clamp, close
the lid and fasten it with the "V" screw.
F
V
1
2
3
4
5