Filter
Top Products
Care and Cleaning
23
Wipe over the outer door glass panels with a cloth wrung out in hot soapy
water, then after wiping with a cloth wrung out in clear water, dry with a soft
clean cloth. Ensure that glass doors are not subjected to any sharp
mechanical blows.
Glass Inner Door Panel (where fitted) – open the door fully and unscrew the
two screws securing the glass panel, taking care not to allow the glass to fall.
The glass panel may now be washed at the sink. Stubborn stains can be
removed by using a fine steel wool soap pad. Ensure the glass panel is not
subjected to any sharp mechanical blows. Take particular care not to damage
the inner surface which is coated with a heat reflective layer. After cleaning,
rinse and dry with a soft cloth. For slight soiling the inner glass panel may be
cleaned, while still warm, without removing it from the door.
Warning: Oven must not be operated with inner door glass removed.
Take care during cleaning not to damage or distort the door seals. Do not lift
the door seal from the oven chassis, if necessary remove the seal by carefully
unhooking the corner clips.
Take care that the rating label edges are not lifted during cleaning, and
furthermore that the lettering is not blurred or removed.
Remove the rod shelves and meat pan.
Use a fine steel wool soap pad to remove stubborn stains from the
rod shelves, meat pan and the floor of the oven.
The surface of the ‘Credaclean’ oven liners are treated on the mottled face with a
special vitreous enamel which absorbs cooking soils. At temperatures of 220
o
C
(425
o
F) or above, the special surface enables these soils to be slowly destroyed.
The higher the temperature the more effective it is. In most cases normal
cooking operation at this temperature will permit this cleaning operation to
proceed during cooking. However if higher cooking temperatures are not used
regularly it may be necessary, to prevent heavy soiling, to run the oven without
a meat pan at maximum setting for a couple of hours. This may be necessary
once a month or once every two or three months depending on the type and
amount of oven cooking.
It should not normally be necessary to clean the ‘Credaclean’ panels in water. If
desirable remove the rod shelves and the side panels and wash them in warm
soapy water, followed by rinsing in clean water.
Open the oven door and remove the rod shelves. Using a suitable cloth to
protect the fingers grip the light glass dome, unscrew anti-clockwise and
lift. Reach into the aperture with fingers, and unscrew the lamp anti-
clockwise. Fit replacement lamp (15W 300
°
C rated SES), refit dome.
Warning: Disconnect the appliance from the electrical supply before
replacing the oven lamp.
Doors
Ovens
Oven Liners
Oven Lamp
Replacement