Filter
Top Products
[ Section 2-Installation ] [ Page 10 ]
UNPACKING INSTRUCTIONS
IMPORTANT:
It is highly recommended that your refrigerator or freezer be installed by an authorized
CresCor Service Agency (List enclosed)
A. Receiving Shipment
Upon arrival, examine the exterior of the shipment packaging for any signs of rough
handling.
If the cabinet is damaged, it should be noted on the delivery slip or bill of lading and signed
to that effect. A claim must be filed immediately against the carrier indicating the extent
and estimated cost of damage incurred.
All units are performance tested and thoroughly inspected prior to shipment. Upon leaving the
factory all units are in perfect condition and the carrier signs to this effect.
B. Uncrating Procedure
WARNING:
DO NOT, Under any Circumstances, Lay Your New Equipment Down on Either The Back,
Front, or Sides!!!
1. Check for any instructions printed on shipping carton.
2. Remove protective cardboard corners, sides and top.
3. Next remove the shipping skid.
4. If any concealed damage is discovered at this time, notify the carrier
in writing, and
retain all carton and packing materials until an inspection has been made or waived
by the carrier. Taking a photo of the damage is recommended.
CAUTION:
Exercise extreme caution when removing the wooden skid.
5. Please Note the Model and Serial Number located on the inside right hand wall of the unit.
Please take the time to write these numbers down and keep in a safe place. A space has been
supplied for this purpose on the last page of this manual. This will assure you quality service
and support in the future. Also take the time to register your equipment to activate the
warranty.