Cres Cor R171SUA10240 Refrigerator User Manual


 
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
for Cres Cor Refrigerated Cabinets,
Model R-171-S Series
Series R-171-S
Refrigerated Cabinets
FL-2314
Rev. 3 (10/06)
Page 2 of 4
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Unplug cord from wall. 1.
Do NOT hose cabinet with water.2.
Do NOT get water into bottom compartment.3.
Do NOT use abrasives or harsh chemicals. 4.
Wipe up spills as soon as possible.
Clean regularly to avoid heavy dirt build-up.
Cleaning Hints:
Use the mildest cleaning procedure that will do the 1.
job.
Always run in the direction of polish lines to avoid 2.
scratching the surface.
Use only a soft cloth, sponge, brous brushes, 3.
plastic or stainless steel pads for cleaning and
scouring.
Rinse thoroughly with fresh water after every 4.
cleaning operation.
Always wipe dry to avoid water marks. 5.
HOW TO CLEAN THE CABINET:
BEFORE cleaning
the cabinet:
Soil Cleaner Method
CABINET
Inside
and
Outside
(Stainless Steel)
ROUTINE CLEANING
Soap, Ammonia, or mild
*detergent and water.
1. Sponge on with cloth.
2. Rinse with water.
3. Wipe dry.
STUBBORN SPOTS
AND STAINS
Mild abrasive made for
stainless steel.
1. Apply with damp sponge or cloth.
2. Rub lightly.
GREASE, OIL
Chemical oven cleaner for
stainless steel.
Follow oven cleaner manufacturer’s
directions.
HARD WATER
SPOTS & SCALE
Vinegar
1. Swab or wipe with cloth.
2. Rinse and dry.
*Mild detergents include soaps and non-abrasive cleaners.
HOW TO REVERSE DOOR HARDWARE FOR OPPOSITE HAND:
(Single Door Cabinet ONLY)
Remove hinge covers with a screwdriver.1.
Open door and lift up to remove door from cabinet. 2.
Unscrew and re-mount the hinges and latch strike to the opposite 3.
sides of the cabinet.
Remove the door hinges and the door latch. Turn hinges and handle 4.
over and remount in the same holes
Remove plastic cam from each hinge, rotate cam 180° with “V” 5.
groove on cam toward inside of cabinet. Reseat cam into hinge.
Plug all the extra holes with screws.6.
Put door onto cabinet and adjust as necessary.7.
Snap on hinge covers..8.
WARNING