Filter
Top Products
7
Note: Overfilling the pressure
cooker (see Instructions for Use)
may clog the pressure limit valve
which can cause excess pressure
to develop.
4. Anti-Block Cover
Prevents any food material from
blocking the pressure limit valve.
5. Pressure Relief Device
When the pressure cooker reaches
the maximum allowable pressure and
temperature, the cooking pot will
move down until lid separates from
the sealing ring, releasing air
pressure.
6. Thermostat
The power will automatically shut off
when the cooking pot temperature
reaches the preset value, or the
pressure cooker is heating without
any food inside.
7. Thermal Fuse
The circuit will be opened when the
pressure cooker reaches the
maximum temperature.
CLEANING
1. Unplug the power cord before
cleaning.
2. Clean the outer body with a soft cloth
such as a paper towel or microfibre
cloth. Do not immerse the outer body
in water or pour water into it.
3. Rinse with warm water the underside
of the lid including the sealing ring,
pressure limit valve, air escape and
float valve. Dry completely.
4. Clean area under upper ring with
dampened cloth or microfibre cloth.
Do not use chemical cleaners.
5. Cooking pot is dishwasher-safe. To
hand-clean the cooking pot, use a
soft cloth or sponge and wipe. Be
careful not to damage the inside
coating. Never use harsh chemicals
or scouring pads.
6. To clean sealing ring, hold the knob
on the sealing ring supporting cover
and pull the sealing ring up. After
cleaning, put the sealing ring
supporting cover back.
TROUBLESHOOTING
Symptom Possible Reasons Solutions
Lid does not lock
The ring is not properly installed
The float is seized by the push rod
Reinstall the ring
Push the rod with hands
Cannot open the lid after air
exhaust
The float is still up Press the float down
Air escapes from the rim of
the lid
No sealing ring was installed
Food residue on sealing ring
Sealing ring worn out
Lid not locked properly
Install the sealing ring
Clean sealing ring
Replace the sealing ring
Rotate lid fully
Air escapes from the float
valve
Food stuck on the sealing ring of
the float valve
The sealing ring on the float wore
out
Clean the sealing ring
Replace the sealing ring
The float will not rise
The pressure limit valve is not
placed properly
Not enough food and water
Air escaping from the rim of the
lid and the pressure limit valve
Place the device to Pressure
• .
Check recipe for proper quantity
Call our Consumer Service Centre
toll free at 1800 808 971 (AUST),
0800 435 000 (NZ)