Cuisinart CPT-90C Toaster User Manual


 
Reheat Button
The Reheat feature allows you to reheat
toasted bread without browning or toasting.
1. Insert slice(s) of bread:
Be sure that multiple slices do not overlap and
the carriage is in the up position.
2. Set the Slice Control Switch to the
1 Slice/2 Slice or 3 Slice/4 Slice
position, as needed.
3. Press the Carriage Control Lever
until it locks into position.
4. Press the Reheat Button.
You do not have to set the Browning Dial as
this cycle will not brown or toast the bread.
To stop cycle:
When the Reheat Cycle is complete, the
toaster will raise the bread. If you wish to stop
the cycle before it is finished, simply press the
Cancel Button to interrupt or lift up on the
Carriage Control Lever. To remove toast, lift
the Extra-Lift Carriage Control until it
reaches its highest point. This is especially
useful when toasting smaller breads.
CLEANING AND
MAINTENANCE
Always allow the toaster to cool completely
before cleaning.
1. Always unplug the toaster from the
electrical outlet.
2. Do not use abrasive cleansers. Simply wipe
the exterior with a clean damp cloth and dry
thoroughly. Apply any cleansing agent to a
cloth, not to the toaster, before cleaning.
3. To remove crumbs, slide out the Crumb
Tray and discard crumbs. Wipe clean and
replace. Never operate the toaster without the
Crumb Tray in place.
4. To remove any pieces of bread remaining in
the toaster, turn the toaster upside down and
gently shake. Never insert any hard or sharp
instruments into the slot as this could damage
the toaster and cause a safety hazard.
5. Never wrap the cord around the outside of
the toaster. Use the cord storage cleats on the
underside of the toaster.
FOR HOUSEHOLD
USE ONLY
6
Cancel Reheat Defrost
2
1
4
3