Filter
Top Products
7. Insert stainless steel motor shaft into center opening of
blade/shaft assembly. Place motor housing directly over
work bowl and fit it into work bowl.
8. Insert plug from motor housing into household
electrical outlet.
9. Grip work bowl firmly in one hand. With other hand, press
down firmly on motor housing and press one control button -
either HI/I for high speed or LO/II for low speed.
10. To turn motor off, release control button.
As motor comes to a stop, you may hear a few clicks from
the blade/shaft assembly. This is normal.
11. Lift motor housing straight up from work bowl after motor
has stopped.
12. Carefully remove blade from bowl. First, release it from post
by twisting hub gently clockwise while exerting slight upward
pressure. Then pull straight up on blade shaft, moving blade
away from you. With spatula, scrape food off blade into
work bowl.
13. Remove food from work bowl with spatula.
USES
Chop, grate and grind small amounts of food. For your conven-
ience, we have listed a number of ingredients alphabetically.
USING THE MINI-MATE PLUS
®
CHOPPER/GRINDER
1. Place work bowl on kitchen counter or other flat, firm surface.
2. Slide hub of blade along blade shaft to select sharp or blunt
blade position. Blade should be at white end of shaft for sharp
edge, at gray end of shaft for blunt edge. Handle carefully.
Never touch blades; always move blade by its shaft.
Select sharp edge for chopping most soft foods. Select blunt
edge for:
• grinding coffee beans, nuts and seeds
• grating chocolate
• puréeing cooked vegetables and ripe fruit.
3. Hold blade/shaft assembly, with blade end down, directly over
post in work bowl.
4. Push blade/shaft assembly down gently over post, twisting
hub slightly clockwise. Assembly will drop into position with
lower blade at bottom of bowl. Assembly must be upright.
It must not tilt.
5. Put food in work bowl.
• Hold thumb or index finger over top of blade shaft to prevent
small pieces of food from entering it.
• Do not overload work bowl. The Mini-Mate Plus
®
Chopper/Grinder is designed for chopping and grinding small
amounts of food. If you want to chop or grind more than 1 or
2 tablespoons, do it in batches.
• Cut large pieces of food into small pieces no bigger than
1/2 inch (12mm) before chopping or grinding.
6. Grip motor housing and place it over work bowl. The power
cord, as well as the control buttons, should be at the rear.
6
5
03CU13007 MM-2M IB Rev 6/23/03 2:11 PM Page 7