Filter
Top Products
10
PROGRAMMING YOUR
COFFEEMAKER
1. Setting the Clock:
When the coffeemaker is plugged in, 12:00 will
flash continuously until you set the time.
Entering “Time Set” Mode:
To set the time, hold down either the “Hours”
or “Minutes” button until the clock stops flash-
ing and begins to count up (about 2 seconds).
You are now in the “Time Set” mode and can
operate either button to achieve the desired
setting. The buttons can be held down to scroll
through the digits, or pressed and released
lightly to advance one digit at a time.
When scrolling, the numbers will advance
slowly at first and then speed up to the rate
of about three per second. When the number
displayed approaches the desired setting,
release the button and press repeatedly to
advance one digit at a time. Be careful to
make sure that the PM indicator is on if a
PM time is desired.
Exiting “Time Set” Mode:
The “Time Set” mode can be exited in
one of two ways:
1. Press any button besides the “Hours” or
“Minutes” button. This will exit the “Time Set”
and activate the selected function.
2. Do nothing. If neither the “Hours” nor
“Minutes” button is pressed for a period
of five seconds, the “Time Set” mode will
be exited.
2. Setting the Program Time:
When you press the “Program Set” button, it
displays the current program time, and the
green light next to the button will light. The
coffeemaker will start to brew at the
programmed time. If no time appears when the
button is pressed and the green light turns off
at the release of the button, it means that no
program time has been set. The “Programmed”
mode cannot be entered until the program time
has been set.
Entering “Set Program Time”
Mode:
Press and hold the “Program Set” button
(about 2 seconds) until the green light begins
to flash. This signals that you have entered the
“Set Program Time” mode. The desired time
can be set by pressing the “Hours” and
“Minutes” buttons to scroll forward through the
digits. Pressing and holding either button will
allow you to scroll continuously, slowly at first,
and then to accelerate to the rate of about
three digits per second. As the desired time
setting approaches, release the button and
then press repeatedly to advance one digit
at a time.
Exiting “Set Program Time” Mode:
“Set Program Time” may be exited in any
of three ways:
1. Press the “Program Set” button. This will
cause the coffeemaker to revert to its
previous state. If it was OFF, it will return
to the OFF position. If “Programmed”, it will
revert to this state, and so on. This is a
safety feature.
2. Press any other button (except “Hours”
or “Minutes”). “Set Program Time” will be
exited and the function of that button will
be executed.
3. Do nothing. If neither the “Hours” nor
“Minutes” button is pressed for a period of
five seconds, the “Set Program Time” mode
will be exited and the programmed setting
will be in effect.
PROGRAMMING AUTOMATIC
SHUTOFF TIME
The Automatic Shutoff Time can be pro-
grammed anywhere from immediate shutoff
after completion of the brew cycle up to four
hours. When the coffeemaker shuts itself off,
two tones will sound. Four hours is the default
time. The 0:00 setting shuts the unit off imme-
diately after brewing is complete. To check the
current setting, press the “On/Off” button and
the Automatic Shutoff Time will be displayed.
To change the preset time, press and hold the
“On/Off” button until the red “power” light
begins to flash. This signals that you have
entered the “Set Automatic Shutoff” mode.
02CU13488 DGB300 IB 6/23/03 2:31 PM Page 10