Filter
Top Products
7
PROGRAMMING YOUR
ESPRESSO MACHINE
The Cuisinart
®
Programmable Espresso Maker
has programming capabilities. Based on café
settings, the
single and
double
espresso functions are set at 1.5 and 3.0 oz.
However, by following a few simple steps, you
can pre-program your perfect serving size down
to the ounce.
Programming
Single Espresso
1. Prepare the portafilter holder with the one cup
filter basket (8) and fill with finely ground
espresso (9). Using the tamping tool, tamp
the coffee grinds (10), or use a single pod of
espresso coffee with the pod filter holder.
Secure the portafilter holder to the brew head
(11-12).
2. Place a cup under both pouring spouts.
3. To begin programming press the program
button. The light around the program button
will show a constant blue light.
4. Press the
single espresso button once to
start the espresso pour (13).The light around
the
single espresso button will flash.
5. Allow the espresso to pour until it reaches the
desired level. Once that is reached, stop the
espresso pour by pressing the
single
espresso button. A beep will signify that the
new setting for the
single espresso
operation has been
programmed and
stored in the machine’s
memory.
6. The espresso machine
will then return to
normal operation mode and is ready to make
another espresso at the push of a button.
Programming
Double Espresso
1. Prepare the portafilter holder. Fit it with the
two-cup filter basket (8) and fill with finely
ground coffee (9). Using the tamping tool,
tamp the coffee grinds (10). Secure the
portafilter holder to the brew head (11-12).
2. Place two cups under both pouring spouts.
3. To begin programming press the program
button. The light around the program button
will show a steady blue light.
4. Press the
double espresso button once
to start the espresso pour (14). The light
around the
button will flash.
5. Allow the espresso to pour until it reaches the
desired level. Once that level is reached, stop
the espresso pour by pressing the
double espresso button. A beep will signify
that the new setting for the
double
espresso operation has been programmed
and stored into the machine’s memory.
6. The espresso machine will then return to
normal operation mode and is ready to make
another espresso at the push of a button
Resetting the Factory Settings
To revert to the original factory settings:
1. Press the program button once.
2. Press and hold down the manual button
and program.
3. Continue holding down manual and program
buttons for approximately 3 seconds or until
you hear 2 beeps. When you hear the 2
beeps, the light around the
and
buttons will flash, and after that, the program
light becomes solid. The espresso machine
13
9
10
11
12
8
14