Filter
Top Products
ASSEMBLY
1. Attach hand mixer to stand
Line up the indent on the back end of the
hand mixer with the tab in the back of
the stand. Place hand mixer on the stand
with tab in indent and push the front of
the hand mixer down onto the stand until
it clicks into place.
2. Remove hand mixer from stand
Push down on hand mixer release button
and lift the front end of the mixer off and
up from the stand.
3. Raise stand head
Push down head lift release lever and
raise stand head until it locks into place.
4.
Lower stand head
Push down on head and fully lower the
stand head until it clicks into place.
5.
To place bowl on base
Line up grooves under bowl with the
grooves on the base and it locks into
place.
USE AND CARE
Inserting Beaters
1. Unplug mixer and set the power switch
to the OFF position.
2. Insert beater with collar into the larger
hole. Push beater in until it clicks into
place. Insert the beater with the plastic
padding on the end into the smaller hole.
Push beater in until it clicks into place.
Inserting Dough Hooks
1. Unplug mixer and set the power switch
to the OFF position.
2. Insert dough hook with collar into the
larger hole. Push dough hook in until it
clicks into place. Insert the dough hook
without the collar into the smaller hole.
Push dough hook in until it clicks into
place.
Note:
Dough hook with collar will also have plastic
padding on the end of the dough hook.
Inserting Chef's Whisk
1.
Unplug mixer and set the power switch
to the OFF position
2. Hold chef’s whisk at stem end, and
insert into smaller hole. Push whisk in
until it clicks. DO NOT PUSH WHISK
IN FROM WIRE END, AS YOU MAY
DAMAGE WIRES.
Turning Mixer On/Off
Plug mixer into outlet. Press On/Off switch
to turn mixer On. Mixer will immediately
begin to mix on Speed 1. To turn mixer off,
press On/Off switch again.
Changing Speeds
Press the + button on the digital touchpad
to increase the speed. Press the - button to
decrease the speed.
CLEANING AND
MAINTENANCE
1. Unplug your Cuisinart
®
Hand Mixer
before cleaning.
Hand Mixer
Release hand mixer from stand by pressing
the hand mixer release button. Then lift the
beater release lever and remove the beaters
from the mixer. Wipe the hand mixer with a
damp cloth or sponge. Do not use abrasive
cleaners, which could scratch the surface.
NEVER PUT THE MOTOR HOUSING IN
WATER OR OTHER LIQUID TO CLEAN.
Bowl
If hand mixer is not on the stand, lift bowl
from base. If hand mixer is on stand, raise
the stand head using the head-lift release
lever and then remove bowl from base.
Wash the bowl by hand and dry thoroughly
or put in dishwasher. Never use a wire
brush, steel wool or bleach.
Stand
Wipe with a damp cloth and dry. Never use
abrasives or immerse in water.
Turntable
NOTE: It is not recommended to take turn-
table off stand. To clean, remove bowl and
hand mixer from stand. Wipe down turn
-
table or wash by hand.
4
Larger
Hole