Filter
Top Products
8
2. Fill the Water Reservoir
The water reservoir can hold up to 60 oz. of
water. The water reservoir can be filled in
one of two ways:
Flip the water reservoir cover open, and pour
water directly into the reservoir until it is full,
or remove the reservoir and bring directly to
the sink. Do not exceed the max fill line.
Return the water reservoir to the unit, and
flip the cover back in place.
NOTE: When the unit is powered on, if the
water reservoir is not in place the Power button
will fast-flash (2 flashes every second). When
the water reservoir is replaced the unit will
begin heating.
3. Power Unit/Begin Heating
Press the Power button to turn the
coffeemaker on. The Power button will begin
to slow-flash, indicating that the unit is on
and heating; it will continue to flash while the
unit is heating.
NOTE: If the unit detects a low water level, the
Power button will fast-flash. If so, fill the water
reservoir (do not exceed the max fill line) and
the unit will begin heating.
4. Add Coffee Grounds/Pod
While your unit is heating, remove brew cup
from unit. Place the brew basket in the brew
cup. Place coffee pod or ground coffee in
the brew basket.
Return the brew cup to the unit.
NOTE: The maximum capacity for ground
coffee is 4 tablespoons.
NOTE: When using ground coffee, if the brew
cup has been overfilled, the unit will not brew.
The unit will beep 3 times and the Brew button
will fast-flash, indicating that you must remove
some of the coffee grounds from the brew
basket. Press the Brew button to resume the
brew process.
NOTE: If the brew cup is not in place when the
brew cycle begins the unit will not brew. The
unit will beep 3 times and the Brew button will
fast-flash. Return brew cup to unit and press
the Brew button to resume the brew process.
5. Customizing your Cup of Coffee
The default settings for this unit are POD/
REG/6 oz. These buttons will be illuminated.
If your preferences differ from these you will
need to change the settings. Select the type,
strength and amount of coffee you desire.
a. Select POD if you are using a pod, and
GRND if you are using ground coffee.
b. If you prefer regular coffee, select REG; if
you prefer a bolder coffee taste, select
BOLD.
c. Choose a size from 4oz. to 12oz.
NOTE: The settings from your last cup of
coffee will remain selected until a) the unit is
unplugged or b) new settings are selected.
If the unit has been unplugged between uses,
the unit will reset to the default settings (POD/
REG/6 oz).
6. Start the Brew Cycle
When your Cup-O-Matic
™
coffeemaker has
reached the correct temperature the Power
light will stop flashing. At this time the unit
will be in standby mode. The Power and
Default/Last-selected Setting buttons will be
illuminated. Check to make sure your
preferred type, strength and amount of
coffee are selected, and place your cup/mug
on the drip tray. You will not be able to
change your settings once the unit is
brewing.
NOTE: To accommodate the Cuisinart travel
mug (or other tall cups) remove the drip tray.
Press the Brew button to begin the brewing
cycle.
7. After Brewing
When the brewing cycle is completed, 5
beeps will sound. Coffee may continue to
stream from the brew basket for several
seconds.
NOTE: The unit will remain in standby mode,
and ready to brew for two hours after use.
To empty the brew cup of used pods/grounds,
remove brew cup from unit. Use the slide lock
to put the brew cup in the locked position. This
will allow you to dump the used pod/grounds
while keeping the brew basket in place.