Filter
Top Products
6
STORING THE UNIT
1. Turn the unit off and unplug it from outlet.
2. Remove empty water tanks, filter and cover.
3. Bring base to sink.
4. Drain internal reservoir by tilting unit slightly and
removing the plastic drainage plug from bottom of
unit. Plug is tightly inserted and must be gently, but
firmly, worked to remove.
5. When water has completely drained, replace plug, tanks, filter and cover.
6. Your Cuisinart Countertop Filtration System is ready to store.
TECHNICAL SPECIFICATIONS
Unit:
WCH-850 1 Cuisinart
®
Countertop
Filtration System
1 Cuisinart
®
Water Filter
System Capacity up to 3-4 months/ 80 gallons/ 302 liters
Maximum Temperature 85.0°F (29°C)
Minimum Temperature 44.6°F (7°C)
Rated Service Flow 10 gallons / 37.85 liters per day
(may vary according to water conditions)
See Performance Data Sheet for specific test conditions and results.
Claims are calculated based on NSF accepted practice of average percent reduction.
The contaminants or other substances removed or reduced by this water treatment
device are not necessarily in all users’ water. Do not use with water that is
microbiologically unsafe or of unknown quality without adequate disinfection before or
after the system. Individuals requiring water of specific microbiological purity should
consult their physician.
The Cuisinart
®
Countertop Filtration System can process up to
approximately 80 gallons/ 302 liters. When the Cuisinart
®
Water Filter (GF-80)
exceeds filtering capacity, filter replacement is essential for the product to perform
as represented. In the United States, replacement filters generally cost $19.99 per filter.
Replacement filters may be purchased at most retail outlets. The performance of
the filter may vary based on local water conditions.
Hot water should not be used with the Cuisinart
®
Water Filter (GF-80) as it will affect
the filter’s performance.
Refer to the Operating Instructions and Cleaning and Care for general unit operation
and maintenance requirements. Testing was performed under standard laboratory
conditions; actual performance may vary.
System Tested and Certified by NSF International against NSF/ANSI
Standard 53 for the reduction of Benzene, Cadmium, Copper, Mercury,
Tetrachloroethylene, Toluene, and Standard 42 for the reduction of
Chlorine Taste and Odor.
Drainage
Plug
Bottom of unit