Filter
Top Products
6
STORING THE UNIT
1. Turn the unit off and unplug it from outlet.
2. Remove empty water tanks, filter and cover.
3. Allow hot water to cool, then bring base to sink.
4. Drain internal reservoir by tilting unit slightly and removing
the 2 white plastic drainage plugs. Plugs are tightly
inserted and must be gently, but firmly, worked to remove.
5. When water has completely drained, replace plugs, tanks,
filter and cover.
6. Your Cuisinart
Countertop Filtration System is ready to store.
TECHNICAL SPECIFICATIONS
Unit:
WCH-950C 1 Cuisinart
®
Countertop Filtration System
1 Cuisinart
®
Water Filter
System Capacity up to 3-4 months/ 80 gallons/ 302 liters
Maximum Temperature 194°F (90°C)
Minimum Temperature 44.6°F (7°C)
Rated Service Flow 10 gallons / 37.85 liters per day
(may vary according to water conditions)
See Performance Data Sheet for specific test conditions and results.
Claims are calculated based on NSF accepted practice of average percent reduction. The
contaminants or other substances removed or reduced by this water treatment device are not
necessarily in all users’ water. Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system. Individuals requiring
water of specific microbiological purity should consult their physician.
The Cuisinart
®
Countertop Filtration System processes approximately
80 gallons/ 302 liters. When the Cuisinart
®
Water Filter (GF-80C) exceeds filtering capacity,
replacement is essential for the product to perform as represented. Replacement filters may be
purchased at most retail outlets. The performance of the filter may vary based on local water
conditions.
Hot water should not be used with the Cuisinart
®
Water Filter (GF-80C) as it will affect the filter’s
performance.
Refer to the Operating Instructions and Cleaning and Care for general unit operation and
maintenance requirements. Testing was performed under standard laboratory conditions; actual
performance may vary.
System Tested and Certified by NSF International against NSF/ANSI
Standard 53 for the reduction of Benzene, Cadmium, Copper,
Mercury, Tetrachloroethylene, Toluene, and Standard 42 for the
reduction of Chlorine Taste and Odour.
Drainage
Plugs