Filter
Top Products
4
To make 2 cups
1. Fill the water reservoir
Lift the reservoir cover. Using a mug or cup
(not included) fill the reservoir with cold water
to 2-cup marking on the reservoir wall. Do not
overfill. Close reservoir cover.
2. Insert coffee pods
Slide out the brew basket. Remove 2 coffee
pods from their wrappers. Place one pod into
each side of brew basket. Be sure that the pods
are sitting flat. Gently push down around the
outer edge of the pods. Slide brew basket back
into the unit completely. (Do not use more than
one pod on the same side at a time.)
3. Set Brew Selector
On the top of unit, move the brew selector dial to
the 2-cup setting (far right). Be sure that the dial
clicks into place.
IMPORTANT: Before brewing coffee:
Make sure you have placed 2 empty mugs or
cups on the unit base. Plug the cord into an
electrical outlet.
4. Power unit
Press the “On” button on the right side of the
unit. The button will light, indicating that the unit
is on.
5. During and after brewing
Do not remove the cups or mugs during the
brewing process. When brewing is complete,
unit will automatically shut off and the On indica-
tor light will turn off. Once the light turns off,
the cups or mugs may be removed. Stir coffee
before drinking to blend the flavors.
CLEANING AND
MAINTENANCE
COMPLETELY CLEAN AND DRY
ALL PARTS AFTER EVERY USE.
Always make sure the coffeemaker is not “On”
and remove the plug from the electrical outlet
before cleaning.
Slide out the brew basket and discard the used
pod(s). The brew basket can be washed in warm
soapy water and rinsed thoroughly, or cleaned
in the upper rack of the dishwasher. Dry all parts
after use.
Do not use any scouring agents or harsh
cleansers on any part of the coffeemaker.
Never immerse base unit in water or other
liquid. To clean base, simply wipe with a clean,
damp cloth and dry before storing. Do not dry
the inside of the water reservoir with a cloth, as
lint may remain.
DECALCIFICATION
Decalcification refers to removing the calcium
deposits that form over time on the metal parts
of the coffeemaker.
For best performance from your Cuisinart®
2-Cup Coffeemaker, decalcify the base unit from
time to time. The frequency depends upon the
hardness of your tap water and how often you
use the coffeemaker.
To decalcify, fill the water reservoir to the 2-cup
level with a mixture of ⅓ white vinegar and ⅔
water. Follow steps 3-5 under the “To make 2
cups” section. One cycle should be sufficient
to adequately clean the coffeemaker. Run one
2-cup cycle of fresh cold water through the unit
before using the unit again to brew coffee.