Filter
Top Products
7
Installation Instructions
Installation
WARNING
• To avoid personal injury, use only the included gas
pressure regulator or a Dacor specified replacement.
• Do not use any power supply other than the one
provided with the system or a Dacor approved
replacement. Do not attempt to modify or bypass the
power supply.
1. Before installation, make sure any access holes for
the power cord and gas tubing have been drilled in
adjoining cabinets as necessary to allow them to
pass through to the electrical outlet and gas cylinder
location.
2. Plug one end of the plastic gas tubing (provided)
into the inert gas connector at the back of the wine
dispensing system.
3. If required route the plastic gas tubing though any
access holes drilled in the adjoining cabinets.
4. Plug the power cord (provided) into the power plug on
the power supply (black rectangular box) mounted on
the back of the wine dispensing system.
5. If required, route the power cord though any access
holes drilled in the adjoining cabinets.
6. Make sure the cable coming from the power supply
(opposite the power cord that connects to the wall) is
connected to the Power Input connector on the back
of the unit. Also, check to make sure that both of the
micro-switches located on the back of the unit are in
the up position.
7. Slowly and gently lift the unit up and back into the final
location. As you do this, have someone gently pull the
gas tubing and power cable through the access holes
into the adjacent cabinets (if necessary). Exercise care
to make sure that the wiring and tubing lines do not
become damaged. Make sure the require 1” (2.5 cm)
space is maintained above and below the unit.
continued...
Connect power
supply output
here
Connect to
120 Vac 60 Hz.
electrical outlet
120 Vac
power cord
Power
supply
These connectors
used by qualified
service personnel only
Inert gas
connector
Plastic gas
tubing