Filter
Top Products
8
Connecting the Water Supply
(Continued)
Slide the brass nut over the sleeve and screw it into the inlet 6.
port.
Place an adjustable wrench on the nut attached it to the 7.
plastic waterline. Maintain position.
Using a second adjustable wrench, turn the lower nut 8.
counterclockwise and fully tighten it while holding the upper
nut in place. Do not overtighten.
Pull on the tubing to confirm the connection is secure. 9.
Connect the tubing to the frame with the “P” clamp.
Turn on the water supply. Check for leaks and correct if 10.
necessary. Continue to observe the water supply connection
for two to three hours prior to moving the refrigerator to its
permanent location. Monitor the water connection for 24
hours. Correct leaks if necessary.
Installation Instructions
Move Unit to Final Position
IMPORTANT: To avoid floor damage, make sure the levelers are
raised (not touching floor) and the refrigerator is on the rollers
before moving.
Place cardboard or plywood under refrigerator. Remove dolly.1.
Move the refrigerator straight back, evenly into the opening. 2.
Be sure that the refrigerator side trims are not interfering with
the door opening. Also, be sure that the water tubing is not
kinked and the power supply cord is on top of the refrigerator.
Plug in Refrigerator
Plug the refrigerator into a
grounded three prong outlet.
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
“P” clamp