Filter
Top Products
10
Installation Instructions
Rotating the Blower for Models:
EH3012, MH3012, EH3612, MH3612 and
EH4212 (Models that are 12 inches high
equipped with a single blower)
Place the hood assembly on a large flat surface.1.
Remove and save the four (4) screws and the duct col-2.
lar from the top of the unit. See below.
Remove and save the four (4) screws and the cover 3.
plate that covers the hole on the back of the hood.
Tip the hood back, so that it lays on its back with the 4.
front pointing up.
Remove the filters from the under side of the hood.5.
Locate the wiring harness. Cut the cable tie that takes 6.
up the slack in the cable. It is located behind the panel
on the right side inside the hood. Also cut the two (2)
cable ties that hold the wiring harness to the brace
inside the hood, on the right side. See below.
Remove and save the nut that holds the wiring harness 7.
cable clamp in place. Remove and save the clamp.
Disconnect the wiring harness connector from the 8.
blower motor.
While supporting the blower from below, remove the 9.
four (4) nuts that hold the blower and mounting plate in
place. Remove the blower from the hood.
Remove and discard 10.
the mounting plate
attached to the blower
motor.
Remove the four (4) 11.
nuts that hold the rear
mounting plate in place
and remove it. See
below.
Attach the mounting plate removed in step 11 (rear 12.
mounting plate) to the blower motor.
Cover Plate
Duct Collar
Rear Mounting
Plate
Remove
and discard
Remove
cable clamp
Remove
cable ties
Wiring
Harness