Filter
Top Products
3-Inch Side Panel Kit
Page 3
STEP 4: Hold the left side panel in
position on the side of the
range. Locate the center
mounting hole. Remove and
retain the screw attached to
the chassis beneath it.
STEP 5: Insert the tabs on the trim
piece into the slots on the
range.
STEP 6: Use the hex head screw (83023) removed from the side, a Torx head screw removed from
the kick panel and the hex screws from the kit to attach the side panel to the range. Three
(3) hex head screws attach the side. One (1) Torx head screw (83709) inserts through the
end cap hole to attach the top of the side panel. One (1) Torx head screw (83709) inserts
through a hole in the front panel to attach the bottom of the side panel.
STEP 7: Reinstall the end cap.
STEP 8: Repeat steps 3 to 7 for the
right side panel. NOTE:
There is an additional hex
screw (83023) in the kit
for the right side panel
because the center mount-
ing screw is not reused as
with the left side (do not
perform step 4).
STEP 9: Reattach the kick panel
to the range by snapping
the ball studs on the back
of the panel into the holes
on the front panel of the
range. Open the door and
reattach the kick panel top
screws removed in step 1.
Reattach screws
Kick Panel
Space between
door and oven
opening
Side Panel
Front Panel
Torx screw
Hex screw
Torx screw
Hex screw
Hex screw