Filter
Top Products
8
In s t a l l a t I o n In s t r u c t I o n s
verIfyIng op e r a t I o n
Before connecting the power plug, turn the 1.
TEMPERATURE and TIMER knobs are set to the OFF
position.
Plug the power cord into the electrical outlet.2.
Operate the warming drawer as outlined in the use and 3.
care manual that accompanied this product.
In s t a l l a t I o n ch e c k l I s t
WARNING
To ensure a safe and proper installation, the
following checklist should be completed by the
installer to ensure that no part of the installation
has been overlooked.
Proper installation is the responsibility of the
homeowner. The importance of proper installation
of your warming oven cannot be over-emphasized.
Has a properly grounded, dedicated, three prong □
electrical outlet been installed for the appliance by a
licensed electrician? See page 6.
Has the mounting platform been installed according to □
the instructions on page 6?
Has the chassis been properly fastened to the □
mounting platform and sides of the cabinet?
See page 7.
Has the drawer been properly installed? □
Has proper operation been verified? □
Have any problems been noted on the warranty card □
or during the on-line warranty activation? Has the
warranty been activated on-line or the warranty card
filled out completely and mailed?
re-I n s t a l l I n g t h e Dr a W e r
Pull the drawer slides all the way out of the drawer 1.
opening.
Gently lower the drawer between the extended slides 2.
until the drawer is suspended by the slide rails.
Slide the back of the drawer mounting brackets under 3.
the drawer mounting clips on the slides.
Push the side of the drawer down onto its locking tab, 4.
until the tab locks into place.
Repeat the same process on the opposite side.5.
Gently open and close the drawer to make sure that it 6.
is properly installed.
STEP 3: Slide mounting
bracket under clip on
slide
Slide
STEP 4: Push front of
drawer down until tabs
lock into place
Clip on slide