Filter
Top Products
IF36 Panel Overlay Installation
Page 5
Pa n e l In S t a l l a t I o n
NOTE: Remove the top door(s) to make panel installation
easier. On three door models secure the inner edges of the
overlays to the door where there are no trim frames using
double sided tape.
With a Phillips screwdriver, remove the trim screws from the •
top trim frame on the freezer and refrigerator door(s).
Remove the trim. •
Lower the overlay panel into the trim frames on the door. •
With the panel in position, replace the top trim. Be sure that •
the panel is inserted completely into the channel for proper
fit and alignment.
Two door models
Refrigerator Doors (Top)
Three door models
Left door
Freezer Door
(Bottom - both models)
Right door