Filter
Top Products
7
In s t a l l a t I o n In s t r u c t I o n s
Installation Checklist
WARNING
To ensure a safe and proper installation, the •
following checklist should be completed by the
installer to ensure that no part of the installation has
been overlooked.
Proper installation is the responsibility of the •
homeowner. The importance of proper installation of
your Dacor appliance cannot be overemphasized.
Is the IVS properly attached to the cutout according to
the instructions on page 6?
Is the duct work completely installed? Are all joints
attached with sheet metal screws and wrapped with
duct tape? See page 6.
Is the range hood wired and grounded according to
these instructions and in accordance with all applicable
electric codes? See pages 4 and 6.
Are the filters properly installed according to the use
and care manual?
Has proper operation been verified?
Has the warranty been activated on-line or the warranty
card filled out completely and mailed?
Verifying Proper Operation
Install the filters.1.
Install the light bulbs.2.
Attach the included suction cup to one of the •
provided light bulbs.
Insert it into one of the light fixtures.•
Screw it into place and remove the section cup.•
Repeat for the remaining light fixtures.•
Verify that the IVS control knobs are in the OFF 3.
position (fully counter-clockwise).
Turn on the main power supply at the circuit breaker 4.
panel or fuse box.
Turn the light and fan knobs clockwise and make sure 5.
the lights and fans operate properly.
If the hood does not operate properly, follow these
troubleshooting steps:
Verify that power is being supplied to the IVS.•
Check the electrical connections to ensure that the •
installation has been completed correctly.
Repeat the above test.•
If the appliance still does not work, contact an •
authorized Dacor service company. If you are unable to
locate a Dacor service company, please contact Dacor
at (800) 793-0093, or visit us on the web at www.Dacor.
com.
Do not attempt to repair the appliance yourself. Dacor
is not responsible for service required to correct a faulty
installation.