Filter
Top Products
7
In s t a l l a t I o n In s t r u c t I o n s
In s t a l l I n g t h e ch a s s I s
WARNING
To avoid personal injury caused by the appliance
falling forward when the drawer is opened, secure
the chassis to the cabinet and support platform as
instructed.
Grasp the warming oven chassis on opposite sides and 1.
slide it partially into the cabinet opening.
Temporarily support the oven in place so that it will not 2.
tilt or fall.
From an adjoining cabinet, reach in behind the oven 3.
and pull the power cord until the plug is next to the
electrical outlet. Do not plug in the power cord at this
time.
After positioning the power cord and plug, slide the 4.
chassis completely into the cabinet until the front frame
is positioned flush against the cabinet face.
Use the screws provided to secure the warming oven 5.
chassis to the cabinet and support platform, (You may
want to drill pilot holes prior to installing the mounting
screws.) Install one mounting screw through the hole
provided in the front. A pair of holes go through the side
of the chassis for mounting to the cabinet walls.
continued...
re m o v I n g t h e Dr a W e r
WARNING
1. Verify that the electrical outlet for the warming
oven meets the Power Supply Requirements on
the facing page before proceeding.
2. Be certain that power plug is disconnected from
the electrical outlet before installation.
Remove the drawer from the appliance to allow access
to the mounting holes during installation, and to reduce
weight:
Pull the drawer out to the fully open position. 1.
Push in on the locking tab on one side as you pull the 2.
drawer up.
When the drawer comes loose on the slide, repeat the 3.
same process on the opposite side.
Grip the drawer on both sides and pull it free.4.
For safety, push both drawer slides into the drawer 5.
opening.
STEP 2: Push
locking tab
Drawer Slide
STEP 3: Pull up on
front of drawer
verIfyIng t h e pa c k a g e co n t e n t s
•Useandcaremanual
•Mountingscrews
•Wirerackwithmountinghardware(IOWOmodelonly)