Filter
Top Products
6
In s t a l l a t I o n spe c I f Ic a t Io n s
Support
platform
Cha ss is
fac e
In s t a l l I n g t h e su p p o r t pl a t f o r m In
t h e ca b I n e t
Provide a platform (100lb. load capacity) within the cabinet upon
which the warming oven will be supported. The platform must
be installed level and straight. The top edge of the platform must
be flush with the cutout at the front of the cabinet. There are no
provisions to level the warming oven after it has been installed.
3/4” (19mm) thick plywood is recommended.
NOTE:
If the oven is not installed in a level fashion, the drawer
may slide open on its own or may not seal tightly, allowing
heat to escape and resulting in poor performance.
po W e r su p p l y re q u I r e m e n t s
WARNING
Electric shock Hazard – This appliance is equipped
with a 40” (1016mm) power cord with a three prong
grounded plug. Plug it only into a grounded three prong
electrical outlet.
• Do not remove the ground prong.
• Do not use a 2-prong adapter.
• Do not use an extension cord.
• Do not use a power cord that is frayed or
damaged.
Failure to comply with the above can result in fire,
electric shock, or death.
The electrical outlet for this appliance must only be
installed by a licensed electrician.
Power cord with
three-prong grounding plug
Grounding type
electrical outlet
The correct voltage, frequency and amperage must be supplied
to the electrical outlet from a grounded, single phase circuit that is
protected by a properly sized circuit breaker or time-delay fuse.
Circuit Requirements:
120 Vac, 60 Hz, 15 Amp. dedicated circuit.◊
Total Connected Load:
Model EWO36: 0.8kW (6.5 Amp.)◊
All other models: ◊ 0.5kW (4 Amp.)
NOTES:
The above specifications are for reference only. Refer 1.
to the product date label for exact specifications. If the
requirements above do not agree with those listed on
the product data label, use the information found on the
label. See inside the front cover for location.
If the electrical service provided does not meet the 2.
product specifications, or does not conform to the NEC
or local standards, do not proceed with the installation.
Call a licensed electrician to install the required
electrical service before proceeding.
3. Be certain to locate the electrical outlet in an
accessible location, so that the warming oven may be
easily unplugged if service becomes necessary.
4. It is the owner’s responsibility to ensure that the
electrical outlet for this appliance has been installed
by a qualified electrician. The electrical installation
must comply with the latest revision of the National
Electric Code ANSI/NFPA 70 and local codes and
ordinances.