Filter
Top Products
5
Standard Burners
Put the burner heads on the burner bases as 1.
shown below. Match the correct sizes. The
bottom of the correct size burner head fits on
top of the matching burner base. Line up the
notch on the bottom of each head with the
ignitor on the matching base.
Twist each head back and forth slightly to make 2.
sure it is properly seated.
Put the cap covers on top of the burner heads. 3.
The ridge around the bottom edge of the cap
cover goes around the top of the burner head.
Grates
Gently set the grates on top of the spill tray. Put the
legs of each grate into the corresponding dimples.
Setting Up Your Cooktop
Burner and Grate Assembly
WARNING
Assemble the burners and grates only when the cooktop
is cool.
SimmerSear Burner
Place the burner skirt over each SimmerSear 1.
burner head and base as shown. On model
RGC365 be sure to match the correct size.
Put the burner cap on the burner head of each 2.
SimmerSear burner as shown below. Center the
bottom of the cap inside the base. On model
RGC365 be sure to match the correct size.
Put the cap cover on top of each SimmerSear™ 3.
burner cap. The ridge around the bottom edge of
the cap cover goes around the top of the burner
cap. On model RGC365 be sure to match the
correct size.
*The burner head on the SimmerSear burner
assembly is permanently attached to the burner
base. It cannot be removed by the customer.
SimmerSear Burner Assembly
Burner Cap
Burner Head*
Base
Skirt
Cap Cover
Wide Side
Down!
Standard Burner Assembly
Burner Head
Igniter
Notch
Cap Cover
Burner Base
Line up notch
with igniter