Dacor RV30 Ventilation Hood User Manual


 
5
Cleaning the Filters
Clean the lters and surrounding areas regularly to pre-
vent grease build-up.
The CLEAN FILTER key indicator light will
illuminate after 40 hours of blower use to
remind you to clean the lters (push the
CLEAN FILTER key to reset). The lters
may need to be cleaned more often based
upon the type and amount of cooking.
Check the lters regularly.
To clean the filters:
Raise the vent to the “up” position to clean the lters.
Remove the grill as described in the Grill Cleaning
section.
The lters are positioned side by side inside the vent
intake. When properly installed, the tops of the lters
lean against the rear intake panel and the lter bot-
toms rest in a slot attached to the front intake panel.
Remove one lter at a time by gently grasping the top
center of the lter and lifting it up and out.
Clean the lters by hand washing them in hot water
with a mild detergent solution. You may also put them
in a dishwasher. Clean the intake panel also (see fol-
lowing page).
Make sure the lters are dry before carefully reinstall-
ing them.
Reinstall the intake grill.
Grill Cleaning
Secure the keypad (see facing page).
Remove the grill with the vent in the raised position.
Gently grasp the grill on both ends. Lift it up, then
rotate the bottom of the grill out of the lower groove.
Clean it regularly. Hand wash it in hot water with a
mild detergent solution. Set the grill on a at surface
and wipe only in the direction of the grill grain.
Do not use any cleaners containing ammonia as this
will damage the anodized aluminum nish. A soft
toothbrush or nylon bristle dish brush may be used to
clean the grill grooves.
After cleaning, reinstall the grill. Align the left and
right edges of the grill with the vertical grill guides
and insert the upper edge of the grill into the slot in
the top cap. Pivot and drop the bottom of the grill into
the lower locating slot.
warning
Clean the vent only in the manner specified.
To avoid dangerous fumes or damage to your vent’s surfaces, use only the types of cleaning solutions specified in
this manual.
To avoid personal injury, turn off the range and vent and make sure all surrounding surfaces are cool before
cleaning.
Always wipe stainless steel (silver colored) surfaces with the grain. To prevent scratching, do not use abrasive
cleaners or scrubbers on stainless steel surfaces.
To avoid damage to the fan, do not reinstall damaged filters.
To avoid damage, do not clean the filters in a dishwasher.
Care and Cleaning
Lift Here
Lift Here
Slide Bottom Out
Removing the Grill
Vertical Grill Guide
(Left Shown)
Grill Mount Groove
Location of Mounting Groove
Top Cap
Rear Intake Panel
Grasp Filet and Lift
Front Intake Panel
CLEAN
FILTER