3
Important Safety Instructions
Before operating the raised vent, verify that pot •
handles or other objects will not interfere with the
raising and lowering of the vent intake. To prevent
spillage and damage to the vent system, turn
cookware handles to the side so that they will not
be hit when the vent moves to the “up” position.
Clean liquid spills immediately. If liquid enters the •
vent intake, then turn off the blower, disconnect the
power supply and carefully wipe up all liquid. See
the Care and Cleaning section of this manual.
Never operate the vent without the filters in place.•
Do not operate the blower if a flame or flare-up •
develops. In the event of a flame, immediately
turn off the blower. Smother the flame or use an
appropriate class dry chemical or foam-type fire
extinguisher.
Do not set or rest any objects, including cookware, •
on top of the vent top cap. Do not interfere with the
movement of the vent intake in any way.
If the vent intake becomes jammed while being •
raised or lowered, immediately press the Up/
Down switch once to stop the intake motion,
then disconnect the power supply. Remove the
obstruction, then restore power and press the Up/
Down switch to continue raising or lowering the
intake.
Clean this appliance only as instructed in this •
manual. Use only the cleaners specified.
Never leave a cooktop or range unattended during •
use.
warning warning
Operation
warning
If the vent intake becomes jammed while being raised
or lowered, immediately press the UP/DOWN key once
to stop the intake motion, then disconnect the power
cord. Remove the obstruction, reconnect the power plug
and press the UP/DOWN key to continue raising or
lowering the intake.
important
The direction of travel of the vent intake cannot be
reversed while it is moving. The intake must complete a
full up or down cycle before changing directions.
To operate the RV raised vent system when the vent
intake is in its lowered position, press and release the
UP/DOWN key on the control panel. The intake will take
approximately ten seconds to reach its uppermost posi-
tion, where it will stop.
The blower will turn on automatically and run on the
high speed setting. Adjust the blower speed by pressing
and releasing either the MEDIUM or LOW keys. The fan
speed may be changed whenever desired, as long as the
vent intake is in the fully raised position. The blower will
not operate if the intake is in any other position.
Turn off the blower in one of two ways: Press and release
the OFF key or lower the vent by pressing and releasing
the UP/DOWN key.
Operating Your Raised Vent
Parts the of Raised Vent - Shown Raised
Appearance varies with model number
Top Cap
Intake
Grill
Control Panel
UP/DOWN
LOW
OFF
MEDIUM HIGH