Filter
Top Products
3
Installation Instructions
Suitable Installation Place
Where the floor is solid and level
• Unstable installation causes vibration and noise of
refrigerator.
• Wooden floor or carpet can be discolored under the
refrigerator.
• Doors look hanged down due to the twist of
refrigerator unless it is leveled.
Where ventilation is good
• More than 5 cm from 3 sides (left, right and back) is
good enough for ventilation.
• Insufficient space causes the noise of vibration,
weakening of refrigerating power and the waste of
electricity.
Where there is little or no heat, moisture
• Direct sun rays, side heat of stove and gas range can
weaken the refrigerating power.
• Avoid location by a sink or where moisture and water
can cause rust and corrosion.
• Avoid location where moisture can cause electrical
problems.
• Use hard board or plank on the concrete/cement floor.
Grounding
Grounding terminal is the green one connected to the
power cord in the back of refrigerator.
Grounding is necessary where
water can splash easily ;
there is much moisture basement etc.;
any wet and/or watery places.
Grounding by using grounding wire
Bury copper plate to whitch grounding wire is connected
25 cm deep in the ground.
Grounding by using short-circuit breaker
Short-circuit breaker is a must where the floor is always
wet, for example, fish shop, restaurant kitchen etc.
Grounding is not necessary
in case of using side-grounded outlet.
You should not connect the ground wire to
water pipe, gas pipe, telephone line, lightening-rod.
There can be an explosion or fire.
Correct usage of Refrigerator
Plug in the refrigerator right after installation.
Set the both compartments’ temperature to “MAX”
to perform preparatory run for 2 or 3 hours.
When the inside is cold enough, put the foods in.
When the surrounding temperature is hot in
midsummer, do not open and shut the doors too often
after installation.
Height Adjustable Feet Installation
Open the fresh food compartment door and lift up
a little. Attach the height adjustable foot to their
holes in the left and right bottom of refrigerator.
Adjust the height by turnning the legs until it
touches the floor.
• Let the right adjustable feet touch the floor firmly,
while the left, smoothly.
Front Cover Installation
Please remove the screws on the front bottom
panel first.
• After installation and/or door leveling, click the front
cover and fasten it with screws.