Filter
Top Products
3. When there is no microwave oscillation
1) When touching START pad, oven lamp does not turn on.
Fan motor does not rotate, but cook indicator in display comes on.
- Check method
2) When touching
START pad, oven lamp turns on.
Fan motor and turntable rotate and cook indicator in display comes on.
- Check method
4. When the door is opened during operation, the count down timer does not stop.
-Check method
5. When the digital clock does not operate properly.
Refer to Circuit Diagram.
* If clock does not keep exact time, you must check resistor R20 and zener diode ZD2.
STATE
POINT
AB
RELAY 2 ON 5VDC GND
RELAY 2 OFF GND 12VDC
STATE
POINT
AB
RELAY 1
ON 5VDC GND
RELAY 1 OFF GND 12VDC
STATE
POINT
AB
1) DOOR OPEN OPEN 5VDC
2) DOOR CLOSED CLOSE GND
CHECK NO METHOD REMEDY
1 Check the stage (ON, OFF) of the door open monitor switch by Replace door open monitor
resistance measurement. switch.
POINT WAVE FORM
IC 1 PIN 8
T:20ms(50Hz)
B
A
RY2
RY2
(TRAY
LAMP)
Q10
42
D10
RY1
(M/W)
41
D8
B
A
RY1
Q9
CN1
1
2
C1
+5V
R9 C2
27
R1
R10
D.O.M SW
A B
27