Daewoo KQG-868G7S Microwave Oven User Manual


 
3
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an
electrical short circuit, earthing reduces the risk of
electric shock by providing an escape wire for the
electric current. This appliance is equipped with a
cord having a earthing wire with a earthing plug.
The plug must be plugged into an outlet that is
properly installed and earthed.
WARNING : Improper use of th earthing plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the earthing instructions
are not completely understood, or if doubt exists as
to whether the appliance is properly earthed. If it is
necesary to use an extension cord, use only a 3-
wire extension cord that has a 3-blade earthing
plug, and a 3-slot receptacle that will accept the
plug on the appliance. The marked rating of the
extension cord should be equal to or greater than
the electrical rating of the appliance.
IMPORTANT NOTE
The wires in this mains lead fitted to this appliance
are cloured in accordance with the following code.
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows : the wire which is coloured
green-and-yellow must be connected to the
terminal in the plug whyich is marked with the letter
‘E’ or by the earth symbol or green-and-yellow. The
wire which is coloured blue must be connected to
the terminal which is marked with the letter ‘N’ or
coloured black. The wire which is coloured brown
must be connected to the terminal which is marked
with the letter ‘L’ or coloured red.
WARNING : The appliance must be earthed.
INSTALLATION
1. Ventilation
Do not block air vents. If they are blocked during
operation, the oven may overheat and eventually
cause a failure. For proper ventilation, allow above
3 inches of space between oven sides, rear and
the minimum height of free space necesary above
the top surface of the oven is 100mm.
2. Steady, flat location
This oven should be set on a steady, flat surface.
This oven is designed for counter top use only.
3. Leave space behind and side
All air vents should be kept a clearance. If all vents
are covered during operation, the oven may
overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference
may result if the oven is located close to a TV,
Radio antenna, feeder and so on. Position the
oven as far from them as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or Splash
when choosing a place to position it, or the
insulation might be adversely affected and
breakdowns occur.
6. Power supply
• Check your local power source. This oven
requires a current of approximately 11 amperes,
230V 50Hz.
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as specified
on this oven. Using a higher voltage may result in
a fire or other accident causing oven damage.
Using low voltage will cause slow cooking. We
are not responsible for damage resulting from
use of this oven with a voltage of ampere fuse
other than those specified.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a
hazard.
7. Examine the oven after unpacking for any
damage such as:
A misaligned door, Broken door, A dent in cavity. If
any of the above are visible, DO NOT INSTALL,
and notify dealer immediately.
8. Do not operate the oven if it is colder than
room temperature.
(This may occur during delivery in cold weather.)
Allow the oven to become room temperature
before operating.