Filter
Top Products
3
If the front of the appliance is slightly higher than the rear,
the door can be opened and closed more easily.
LEVELING
To Prepare your appliance for use and check that it is
running correctly, take the following steps.
1. Install removed all shelves and compartments during
transport in the correct positions.
2. Clean the fridge / freezer and accessories to remove any
dust that accumulated during packing and shipping.
3. The interior light should be turned on when the
refrigerator door’s opened
4. Set the temperature control to the coldest temperature
and let the refrigerator operate for one hour.
The freezer should get slightly chilled and the motor
should run smoothly with a soft hum and no noise.
Your fridge / freezer is operated by a compressor which
switches “on and off” to maintain the internal temperature.
When compressor is new, it requires running in for a
period of up to five months.
During this period, it may be slightly noisy.
This is quite normal and does not represent a fault.
5. Store food once the temperature in the refrigerator is
sufficiently low. It takes a few hours after starting the
refrigerator to reach the proper temperature.
If the appliance does not operate correctly, check the
electricity supply.
If the problem persists, contact your dealer.
Preparing The Fridge / Freezer
This product has been designed, constructed and marketed
in accordance with EEC directives 2006/95/CE,
2004/108/CE, and 96/57
Please read this manual carefully to ensure maximum
satisfaction from your appliance. Keep the manual in a safe
place for future reference.
For drawings referenced in the text below, see flap at back
of the manual.
CE
1. The appliance tilts down to the
left.
Turn the left adjusting leg in the
direction of the arrow until the
appliance is lever.
2. The appliance tilts down to the
right.
Turn the right adjusting leg in the
direction of the arrow until the
appliance is lever.
Use of an earthed socket exclusively
For the appliance :
• If you are using a socket with an earthed terminal, you do
not require a separate earthed connection.
Use of a non-earthed socket :
• Connect the “earthed wire” to the steel plate and bury it at
depth of at least 25cm in the ground.
Caution