Filter
Top Products
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
WARNING
Electrical Requirements
Properly Polarized
and Grounded Outlet
3-Prong
(Grounding) Plug
Recommended Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused,
grounded electrical supply is required. It is recom-
mended that a separate circuit serving only your refrig-
erator be provided. Use an outlet that cannot be turned
off by a switch. Do not use an extension cord.
Note: Before performing any type of installation, clean-
ing, or removing a light bulb, turn the Thermostat Control
(or Refrigerator Control depending on the model) to OFF
and then disconnect the refrigerator from the electrical
source. When you are finished, reconnect the refrigera-
tor to the electrical source and reset the Thermostat
Control (or Refrigerator Control) to the desired setting.
To Reverse Door Swing
(Pictured as doors will look when reversed.)
1. Remove top hinge and lift door off the bottom
hinge.
2. Remove door plugs, and two screws that hold
door handle to the door.
3. Mount door handle to the opposite side and door
plugs to the remaining holes on the face of the
door.
4. Remove lower grille
5. Remove bottom hinge and move to the opposite
side.
6. Remove bottom hinge pin by unscrewing nut on
bottom of hinge and reassemble hinge pin on
other hole on the bottom hinge.
7. Put door on bottom hinge, align with cabinet and
secure with top hinge.
8. Make sure all hinge screws are tight.
9. Replace lower grille and upper hinge cover
Nut
Bottom Hinge Screws
Before you move your refrigerator into its final location, it
is important to make sure you have the proper electrical
connection:
5
Top Hinge
Door Plugs
Hinge Screws
Hinge Cover
Hinge Pin
Door Stop
Hinge
Door Stop
Screws