Filter
Top Products
INSTALLATION INSTRUCTIONS
Remove exterior and interior packaging, wipe the outside thoroughly with a soft dry cloth and the inside with a wet, lukewarm
cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or moisture. Let air circulate freely
around the unit. Keep the rear of the refrigerator 5 inches away from the wall.
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between the back of the refrigera-
tor and any adjacent wall. Allow 2 inches (minimum) all
around the appliance.
3) Avoid direct sunlight and heat. Direct sunlight may affect
the acrylic coating. Heat sources nearby will cause higher
electricity consumption.
4) Avoid very moist places. Too much moisture in the air will
cause frost to form very quickly on the evaporator, and
your refrigerator will have to be defrosted more frequently.
CHOOSING THE RIGHT LOCATION
INSTALLATION
Place the appliance on a firm solid base. Some appliances
have adjustable feet on the front side; use them to level the
appliance.
CONNECTION TO POWER
SUPPLY
Connect the appliance power cord to a properly grounded
wall outlet. The required nominal voltage and frequency are
indicated on the rating plate (inside the unit or on the exterior
rear wall of the unit.)
BULB REPLACEMENT
Before replacing the light bulb disconnect the appliance from
the power supply. Using a phillips screwdriver, remove the
screw located in the center of the light cover. Pull the light
cover straight down. Replacement light bulb must be the
same wattage as the original bulb (15 watts only.) Replace
cover in opposite order of removal.
3