Filter
Top Products
6
Operating Instructions
The Controls of your
Beverage Center
To start the Beverage Center, turn the tempera-
ture control to the position corresponding to the
desired cooling. The Beverage Center tempera-
ture will vary depending on the quantity of cans
stored and on the frequency with which the door
is opened.
Setting The Temperature Control:
The temperature of the Beverage Center com-
partment is controlled by adjusting/setting the
thermostat control knob, located on the exterior
rear wall of the cabinet.
To start the Beverage Center and achieve maxi-
mum cooling quickly;
• Turn the temperature control knob clockwise to
the furthest (maximum) setting on the darker blue
(wide) section of the graduated control dial.
• Allow the unit to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back
the temperature control knob setting to the 2
o’clock position on the graduated blue control
dial. See fig.15.
• To turn off the beverage center, (no cooling)
rotate the control knob to the “0” (off) position.
See fig.14
T
urn the control to the “OFF” (0) position to tem
-
porarily disconnect the cooling cycle. When the
beverage center is not to be used for a long peri
-
od of time, disconnect the plug and leave the
door partially open.
NOTE: W
ait 3 to 5 minutes before restarting if
operation has been interrupted.
Interior Light:
The operation of the interior light can be "manu-
ally" controlled as well as controlled with the
opening or closing of the door.
To manually operate the light; depress the inte-
rior light toggle switch situated on the left side of
the interior light housing located on the ceiling
of inner cabinet (
as shown in
Figure C) this will
allow the interior light to remain on, while the
door is closed.
Defrosting:
Your beverage center is designed with an “Auto-
Cycle” defrost system.
What is Auto Cycle
defrost?
The refrigerated surfaces of the fresh food com-
partment defrost automatically
, during the “of
f”
cycle of the cold control. (thermostat) Defrost
water from the fresh food compartment is dis
-
posed of automatically
, by means of being chan
-
neled onto a drip tray located on the compressor.
Heat transfer from the compressor causes the
defrost water to evaporate.
Fig. A
Fig. B
Interior Light
Toggle Switch
Fig. C