Filter
Top Products
6
Operating Instructions
Setting the
Temperature
When you plug in your bever-
age center for the first time,
the temperatures will auto-
matically be set to 54°F
(12°C) and will be displayed
in the Fahrenheit scale (°F).
• To switch the display
between the Fahrenheit (°F)
and Celsius (°C) scale,
depress the and
control buttons simultaneou-
sly for approximately 3 seconds.
• The temperature range can
be set as low as 39°F(4°C)
or as high as 64°F (18°C) to
suit your specific storage
requirements. Each depres-
sion of the or but-
ton will allow you adjust the
temperature in 1° degree
increments within the afore-
mentioned range.
The Controls of your
Beverage Center
1.
Indicator light illuminates to signify the
cooling mode is currently in operation.
2. ‘ ’ Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. ‘ ’ Button
To control the inner light turn ON/OFF.
(If press this botton,the inner light is
not controled by The extrusion-board of
lamp swith and keep lighting.)
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
5. ‘
’
Button
Used to raise (warmer) the temperature
in 1° degree increments.
‘
’
Button
Used to decrease (cooler) the
temperature in 1° degree increments.
°C
°F
Function
Instructions
• Temperature Memory Function
Temperature Memory Function
In the event of a power interruption, wine cooler can remember the
previous temperature settings, and when the power is recovery,the
cabinet temperature will go back the same setting temperature as
power off.
• Door Close Reminding Alarm Function
Door Close Reminding Alarm Function
When you forget close the door or the door is not closed completely,
the buzzer alarm after 5 minutes. Please close the door completely
and advoid the cold energy was lost.
• Temperature Alarm Function
Temperature Alarm Function
If the inner temperature is higher than 74°F(23°C), “HI” will be illuminated
on the display panel and the buzzer alarm will come on after one hour.
This informs that the inner temperature of the unit is too high, please
check the unit and fix the problem.
If the inner temperature is lower than 34°F(1°C), “LO” will be illuminated in
the display panel. Also the buzzer alarm and the malfunction indicator
light will be illuminated at the same time.
If put in too more bottles of wine at
one time or the door is not been
closed tightly,then there may show
signal "HI"at the diapaly panel.This
is the normal phenomenon,please
wait for a while after close the door,
”HI” will disappear.
It is normal that the the cabinet shows
“HI” or “LO” between times, If it occurs
frequently or last for a long time, you
can get power off then restart to solve
it. If the problem occurs once again
after restart, Please contract the after-
sale service for help.
NOTE !
3