Filter
Top Products
Operating Instructions
Installation Instructions
Safety Instructions
Troubleshooting Tips
12
OVERFLOW CONDITIONS:
The dishwasher is designed to detect/monitor water overflow conditions. The overflow tube is located in the lower (well)
section of the inner door liner. This tube must be kept free and clear of obstructions and debris. In the event of an overflow
condition, the water level rises above the height of the overflow tube and is directed into the overflow container.
(located at the lower right side of the dishwasher)
When the water level reaches a predetermined height, the float switch is activated closing power to the water inlet valve and
automatically turns on the pump to evacuate the water inside the tub only. The accumulated water inside the float container
must be discharged manually before the dishwasher can be re-started. To empty the float container, follow the instructions below.
BUILT-IN DISHWASHER (MODEL):
• Remove the kick-plate by pulling forward.
• Disconnect the dishwasher from the electrical power supply.
• Disconnect the flexible (braid) hose from the water inlet valve.
• IMPORTANT: Keep the dishwasher upright at all times.
• The overflow container is located at the lower right side of the dishwasher. (See Fig. 1)
• Carefully slide out the dishwasher just enough to access the overflow container.
• Remove the rubber plug from the bottom of the float container. (See Fig. 2)
• Allow the water to drain into a cup/container.
• Replace the rubber plug, making sure it is firmly secured.
• Re-install the kick-plate.
• Carefully slide the dishwasher back into the cabinet.
The dishwasher is now ready to be restarted.
Float Container
Plug
Fig. 1
Fig. 2