Filter
Top Products
Library imaging System
Figure 5
4. Install new door latch assembly and reverse procedures to complete repairs,,
FLOAT SWITCH ASSEMBLY
The water float assembly is located in the right lower side of the dishwasher (the
portable located behind the lower front crosspiece).. When too much water enter
the dishwasher, the water will enter the float support through the overflow pipe,
the float will make the floating .switch acts, the electrical supply to the water valve
will disconnected and the drain pump keep on working.
If the switch fails to operate, check the following:
o Loose connection at the switch terminal
• Switch not installed properly.
, Warped stem on float, not contacting the actuator blade,
, Float support restricts free float movement.,
° Check if the float support is cracked
. Food or foreign material restricting free float movement.,
• If the rubber ca lost(See
Figure 7
To Remove Or Replace Float Switch
1, Disconnect dishwasher from electrical supply.
2, Remove electrical leads to float switch,
Take down the switch from float support,,
4. Install new float switch and reverse procedures to complete repairs (See figure 6),,