Filter
Top Products
Installation Instructions
The refrigerator temperature will vary depending on the quantity of food
stored and the frequency with which the door is opened.
NOTES:
• This appliance is intended for FREE-STANDING INSTALLATION ONLY,
and is NOT intended to be built-in.
• Before connecting this appliance to electrical power supply, leave it to
stand for approx. 24 hours, which will reduce the possibility of
malfunction in the cooling system due to transport handling.
• This appliance is approved for INDOOR USE ONLY and is NOT
intended for outdoor operation.
IMPORTANT
Install this appliance in an area where the ambient temperature is
between 55°F (13°C) and 110°F (43°C). If the temperature around
the appliance is too low or high, cooling ability may be affected.
DOOR REVERSAL
INSTRUCTIONS
Your refrigerator is built with a reversible door. You have the choice of
either opening it from the left or the right side. In order to reverse the
opening direction of your door, please follow these simple instructions:
IMPORTANT
Before you begin, unplug refrigerator or disconnect power.
Remove food and any adjustable door or utility bins from doors.
DOOR AND HINGE REMOVAL
1. Unplug refrigerator or disconnect power.
2. Keep both doors closed until you are ready to lift them free from the
cabinet.
NOTE: Provide additional support for the doors while the hinges are being
moved. Do not depend on the door magnets to hold the doors in place
while you are working.
3. Remove the parts for the top hinge as shown in Top Hinge graphic. Lift
the freezer door from the cabinet.
4. Remove the parts for the center hinge as shown in the Center Hinge
graphic. Lift the refrigerator door free from the cabinet.
5. Remove the parts for the bottom hinge as shown in the Bottom Hinge
graphic. (see page 5)
DOOR REVERSAL CABINET
1. Remove the cover of upper hinge hole from left side and move them to
opposite side (see Graphic 1).
2. Remove hole plugs from left side and move them to opposite side
(see Graphic 2 on page 5)
DOORS
1. Remove door hinge hole plug from the top of freezer and refrigerator door
(see graphic 4 on page 5)
2. Remove the door stop from refrigerator door and move to the other side
(see graphic 5 on page 5)
3. Take out the left door stop of freezer door and screw from the accessory
bag and fix it on the handle (see graphic 3 on page 5)
4