Filter
Top Products
Installation Instructions - Door Swing Reversal
8
TOOLS REQUIRED
TOOLS REQUIRED
Phillips #2 screwdriver and an adjustable wrench.
WARNING!
WARNING!
Excessive Weight Hazard
Use two or more people when moving
the wine cooler.
1 Rubber cover
2 Screws
3 Decorative cover
4 Screws
5 Top hinge
6 Decorative nail
7 Screws
8 Lower hinge
9 Cabinet leg
10 Extrusion-board
of lamp switch
11 Screws
12 Decorative nail
1ˊClose the door and take out rubber cover (1), unscrew two screws (2) and remove
decorative cover (3). (Fig.1)
2ˊUnscrew screws (4) and take out top hinge (5), then remove the door. (Fig. 2)
3ˊPut door safety, unscrew decorative nail (12) and take out 2 screws (11) at bottom,
pull out extrusion-board of lamp switch (10) and fix it at top of door. Block holes at
bottom of door with spare decorative nail. (Fig. 5)
4ˊPull out decorative nail (6) from left top of cabinet. (Fig.3)
5ˊUnscrew 3 screws (7) from right bottom of cabinet and remove lower hinge (8). (Fig.4)
6ˊPull out cabinet leg (9) from left bottom of cabinet and fix it onto right bottom of
cabinet. (Fig.4)
7ˊFix the lower hinge (8) onto left bottom of cabinet with screws (7). (Fig. 4)
8ˊThe door revolves 180 degrees, put lower door axis to aim at lower hinge (8) and
install the door onto lower hinge (8), then close the door carefully. (Fig.5)
9ˊFix top hinge (5) onto left top of cabinet with screws (4), adjust door and install
decorative cover (3) and rubber cover (1). (Fig.6)
10. Block 3 screw holes at right top of cabinet with spare decorative nail.