Filter
Top Products
INSTALLATION INSTRUCTIONS
DOOR
REVERSAL
NOTE: You will require a #2 Phillipshead screwdriver and an adjustable wrench.
1) Unplug the unit from the electrical outlet (if connected) and lay it on its back.
2) Remove the screws from the lower hinge assembly.
3) Pull the door downward to remove it from the cabinet of the Wine Cooler.
4) Remove the upper hinge pin from the top left side of the cabinet and reinstall it on the top right side.
5) Remove the plastic cap from the left side of the door frame and reinstall it on the right side of the
doorframe (the previous pin location).
6) Carefully reposition the door on the cabinet and push up until the top hinge pin is inserted into the top of
the door.
7) While the door remains closed, install the lower hinge assembly.
8) Close the door and return the unit into its upright position (wait 60 minutes before reconnecting power to
the Wine Cooler), verify the door alignment and proper seal against the cabinet.
5