DCS OUTDOOR REFRIGERATOR AND BEVERAGE ALL REFRIGERATOR Refrigerator User Manual


 
HOW TO INSTALL YOUR
OUTDOOR REFRIGERATOR . . .
1. Select Location: The proper location will ensure peak
performance of your appliance. Choose a location
where the unit will be out of direct sunlight and away
from heat sources. Units with fan cooled condensers
can be built in.
Unit should be operated in a properly ventilated area
with ambient temperatures above 40 degrees and be-
low 100 degrees Fahrenheit.
Installation should be such that the cabinet can be
moved for servicing if necessary.
2. Cabinet Clearance: Ventilation is required from the bot-
tom front section of the unit. Keep this area open and
clear of any obstructions.
The adjacent cabinets and counter top can be built
around the unit as long as no top trim or counter top is
installed lower than the top of the hinge.
3. Electrical Connection: Check serial plate for correct
power supply. Use only electrical power supply as speci-
fied on your appliance serial nameplate. Do not use
an extension cord!
FIGURE 1
The plug shown is for 115V. units. The prongs on your
model may be different than the one shown if your unit
is other than 115 volts.
- 2 -
WARNING!
Do not splash or spray water from a hose on the
refrigerator!
Doing so may cause an electrical shock, which
may result in severe injury or death.
Grounding Method -- This product is factory equipped with a power supply cord that has a three-pronged grounded
plug. It must be plugged into a mating grounding type receptacle in accordance with the National Electrical Code and
applicable local codes and ordinances. If the circuit does not have a grounding type receptacle, it is the responsibility
and obligation of the customer to exchange the existing receptacle in accordance with the National Electrical Code and
applicable local codes and ordinances. The third ground prong should not, under any circumstances, be cut or removed.
All U.L. listed refrigerated products are equipped with this type of plug.
A ground fault circuit interrupter electrical receptacle is to be used to supply electrical power to the refrigerator for
outdoor applications. Contact an electrician if you need to install one to supply electrical power to your outdoor refrigerator.