DCS RDS-485GD Range User Manual


 
Do not use aluminum foil to cover the oven racks or to line the oven. Heat can be trapped beneath
the foil, this can cause damage to the oven and the food may not cook correctly.
3) Before baking or broiling:
One at a time turn the oven and broiler burners for 20 to 30 minutes each. This burns off the
manufacturing oils used by the factory. Turn the oven burner on to 450ºF and the broiler burner on
to “Broil”.Turn on the ventilator above your range while these burners are on, as there will be
an odor.
TO INSERT THE OVEN RACKS:
1) Hold the rack with the back safety rail in the up position and towards the rear of the oven.Slip it
into the oven so the rack slides are between the rack and the rack guides.
2) As you slide the rack into the oven tip the front of the rack up slightly,so that the safety stops on
the back of the rack,clear the rack slides. The safety stops keep the rack from sliding out of the oven
when pulled forward.
TO REMOVE OR REPOSITION THE RACKS:
1) Pull the rack forward.
2) Lift the front of the rack up so the safety stops clear the rack slides.
3) Pull the rack forward.
BEFORE USING YOUR APPLIANCE
8