DCS VS1236 Ventilation Hood User Manual


 
8
TO CLEAN HOOD SURFACE
For general care,wipe the outside of the stainless steel with sudsy water or household cleaners
such as Fantastic® or Formula 409®, rinse well and dry with clean soft cloth to avoid water
marks.
Wipe and dry brushed stainless steel in the same direction as the grain.
Do not use abrasive products.
To remove finger prints and give added shine use spray cleaners such as Stainless Steel Magic®
and Shimmer®
LIGHTS
CAUTION:
Before replacing the lamps,switch power off at service panel and lock service
panel disconnecting means to prevent power from being switched on
accidentally.
NOTE: Turn off the lights and fan. Allow the lights to cool before handling. If new lights do not
operate,be sure lights are inserted correctly before calling service.
REPLACE LIGHTS
Remove the damaged light (twist counter clockwise) and replace with a new 120 Volt,50 Watt
(maximum) 50° halogen light made for a GU10 base.
WARNING:
Halogen lamps are constructed of a glass bulb with a pressurized internal
filament tube that operates at high temperatures and could unexpectedly
shatter. Should the outer bulb break,particles of extremely hot glass could be
discharged into the fixture enclosure and/or surrounding environment,
thereby creating a risk of personal injury or fire. When replacing the bulb,let
the bulb cool, and assure that power to the light has been turned off. Never
allow the hot bulb to come into contact with water. DO NOT TOUCH the Light
Bulb when in use. They may be hot enough to cause injury.
INFRARED LAMP AND PANEL KIT:
Optional infrared lamp and panel kit can be ordered separately and mounted into your vent hood:
Models available are IR30,IR36 and IR48.
WARNING
To avoid any electrical shock the installation of the IR lamp should be done by
a qualified electrician and before starting the installation of the hood.
USE AND CARE