Filter
Top Products
8
Red dot plates
•
Plates featuring a red dot in the centre are high speed, high
wattage plates for increased performance
•
For your safety these plates are fitted with thermal limiters.
Should a plate be accidentally switched on and left unattended,
the limiter will reduce the power output of the plate and mini-
mise the risk of overheating and the possibility of fire.
Solid plates
Caring for Solid Plates
•
Before using the plates for the first time, switch them on for about 4 minutes at the
highest setting. This allows the factory applied protective coating to burn in.
•
To prevent blotchy discolouration and corrosion, moisture from spatters and spills
should be cleaned off immediately.
•
To clean the plates, wipe them with a damp cloth or nylon pad. A little liquid detergent
may be used. Do not use metal scourers or sharp metal objects to clean the plates.
•
After cleaning, dry the plates by switching them on for a short while.
•
To prevent rust, periodically apply some sewing machine oil or electrical hotplate pol-
ish -
available from Defy Service Centres. Extra attention is required in areas of high
humidity or in close proximity to the sea.
Recommendations
•
Use only pots with a solid level base. An uneven base can prolong cooking times and
waste energy.
•
Use pots with a base diameter slightly larger than the plate. This will ensure even heat
distribution and prevent spillage from dripping onto and staining the hot plate.
•
Always cover the pot with a lid. This will conserve energy and minimise spillage.
•
Thermal shock could damage the plates. Do not put cold pots on very hot plates.
•
Plate controls
•
Select the heat level by turning the relevant plate control knob to the required setting.
•
The higher the number selected, the hotter the temperature of the plate will be.
•
The plate indicator light will glow when a plate is switched on.
NOTE: THE WARRANTY DOES NOT COVER THE REPLACEMENT
OR REPAIR OF RUSTED OR CORRODED PLATES.