Filter
Top Products
12
Progress indicator lights
Progress of the wash cycle may be
monitored by observing the progress
indicator lights on the control panel.
Operation
Open the door of the machine.
Load the dirty dishes into the baskets.
Check that the upper and lower spray
arms can rotate freely.
Add detergent.
Check the rinse aid and water softener
(salt) indicators and replenish if
necessary.
Close the dishwasher door.
Switch on the electricity.
Open the tap.
Press the on/off button. The on/off
indicator light will glow.
Push the programme selector knob to
release it and turn to the desired
programme (see programme guide on
following page)
It will not affect the operation of the
machine if the knob is left in the out
position. However pushing it in again
will prevent accidental operation.
Press the start/stop button and check
that the indicator light glows.
The machine will complete the selected
wash cycle and automatically dispense
detergent, rinse aid and salt if required.
Do not open the dishwasher door during
the programme cycle.
Press the on/off button after the
programme is completed.
Close the tap and switch off the
electricity supply to the machine.
Open the door slightly and allow the
dishes to cool for about 15 minutes
before removing them.
First unload the lower and then the
upper basket to prevent drops falling
on the dishes below.
The door should not be left fully open
as this could present a tripping hazard.
Operation
Defy Dishmaid