Filter
Top Products
Page 5
4
9
0
2
7
5
Aperture cut into counter top
Installation
• After carrying out the necessary electrical
connections, fit the hob sealing putty
(supplied) underneath the perimeter rim of
the hob and gently lower the hob into and
over the cavity in the counter top. See
sketch below.
• Secure the hob to the counter top from
underneath, using the brackets provided.
Securing holes are located at each corner
of the hob base for this purpose. See
sketch below
• Carefully trim away any putty exposed
round the perimeter.
Fixing holes are located at each
corner of the hob base
SECURING BRACKET
AND SCREW
HOB
THICKER
COUNTER TOP
STANDARD
COUNTER TOP
HOB
SECURING BRACKET
AND SCREW
SEALING PUTTY
SEALING PUTTY
DANGER Risk of electric
shock, short circuit or fire by
unprofessional installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and
the appliance is only guaranteed
after correct installation.
DANGER Risk of electric
shock, short circuit or fire by
damage of the mains lead!
The mains lead must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance. If the mains lead
is damaged, it must be replaced
by a qualified electrician.
DANGER Risk of electric
shock! Before starting any work
on the electrical installation,
please disconnect the appliance
from the mains supply.
The power cable plug must be
within easy reach after installation
(do not route it above the hob).
Electrical installation
This appliance must be earthed. The
manufacturer and the seller do not accept
responsibility for any damage due to
incorrect installation or electrical connection.
Note: The appliance is not intended to be
operated by means of an external timer or
separate remote-control system.
The hob is fitted with a 15 Amp 3 pin plug
which may be inserted into a conveniently
located 15A earthed socket located in an
easily accessible position, under the counter
and in close proximity to the hob.
If the hob is to be permanently connected to
the power supply a qualified electrician must
install a circuit breaker having a contact
opening distance of at least 3 mm. that
allows complete disconnection.
Invert the hob on the worktop adjacent to the
aperture before making the electrical
connection. This will allow sufficient cable
length for subsequent servicing.