Filter
Top Products
4. Attach the right side panel
to the mounting floor in the
same manner as the other two
panels. Lock the side locking
cams on the inside bottom
and side of the panel. Insert
T-handle wrench and twist
clockwise until a positive stop
is achieved.
NOTE: Ensure all cam locks are in the open position before
placing any panels.
NOTE: Do not break alignment block when placing panels in
place.
5. Attach the front panel
in the same manner as the
others. Front panel will
wrap around the sides.
Lock all side and bottom
cams when the panel
is in position. Insert T-
handle wrench and twist
clockwise until a positive
stop is achieved.
• Attach the Left side deflector shield to the front panel with
provided screws. The shield should cover the corner.
6. Place the top panel on to the top of the cabinet with
the refrigeration holes facing the first panel. Tread the
refrigeration pipes through the supplied holes and ensure
there is no binding.
NOTE: Ensure all cam locks are in the open position before
placing any panels.
Lock all side cams when the panel is in position. Insert
T-handle wrench and twist clockwise until a positive stop is
achieved.
7. Place the control panel on the outside of the top and front of
the unit. Attach with supplied screws and screw holes.
1. Hole for Probes
2. Electrical Hole
3. Refrigerant Line Holes
T40 Installation and Assembly