Filter
Top Products
20
OPERATING INSTRUCTIONS
SOLUTION
Heat the cups by rinsing them in hot water
or leaving them to rest for at least 20 min-
utes on the cup warmer tray (see section 5
note 3).
Heat the infuser by pressing the button
before making the coffee (Fig. 14, see note 3,
section 5).
Turn the espresso/coffee flavor knob (Fig.
7) a little clockwise (see section 5 note 2)
Turn the grinding coarseness regulator (Fig.
17) one click counter-clockwise (see section
6).
Use another brand of coffee blend.
Turn the grinding adjustment knob (Fig. 17) one
click clockwise (see
chap. 6).
Turn the espresso/coffee flavor knob (Fig. 7) a
little counter-clockwise.
Turn the grinding adjustment knob (Fig. 17) one
click counter-clockwise (see section 6).
Turn the espresso/coffee flavor knob (Fig. 7) a
little clockwise.
PROBLEM
• The espresso / coffee is no
hot.
• The coffee is not creamy
enough
• The coffee comes out too slow-
ly
• The coffee comes out too
quickly.
CAUSE
• The cups have not been pre-
heated.
•The infuser is too cold.
• The machine uses too little cof-
fee during the infusion process.
• The coffee is ground too
coarse.
• The ground coffee is not correct
• The coffee is ground too fine.
• The machine uses too much cof-
fee during the infusion process.
• The coffee is ground too
coarse.
• The machine uses too little cof-
fee during infusion.
If the machine is not working and an alarm light is on, the causes of the malfunction can be identified and resolved by
referring to section 12. If, on the other hand, no alarm light is on, run the following checks before calling the service
center.
LIGHTS
DESCRIPTION
MEANING
ACTION
The light is on
steady and the green
lights are flashing.
Insert the infuser, see section 10.2
The inside of the machine is very
dirty.
Thoroughly clean the inside of the
machine, as described in section
10.2
After cleaning, the infuser has
probably been left out of the coffee
maker
13 PROBLEMS THAT CAN BE RESOLVED BEFORE CALLING THE SERVICE CENTER
10
The light is
flashing
The ground coffee funnel is
clogged.
Empty the funnel with the help of a
knife, as described in par. 7 note 5
(Fig.20).
11