Filter
Top Products
DESCRIPTION OF APPLIANCE
(See diagram on page 3)
The following terminology will be used continuously
in the following pages
A. Filter holder
B. Water tank
C. Coffee lid
D. Chlorine filter
E. Boiler cap
F. Steam boiler
G. Steam knob
H. Emulsifier
I. Milk tank
J. Coffee measure
K. Anti-spray hood
L. Pipe brush
M. ON/OFF cappuccino switch (steam boiler)
N. Display
O. AUTO key
P. 1-4 cups key
Q. ON/OFF coffee key
R. HOUR key
S. MIN key
T. ON/OFF coffee light
U. 1-4 cups light
V. AUTO light
W. OK light
X. ON/OFF cappuccino light (steam boiler)
Y. Coffee filter
Z. Hot plate
Z1.Water level indicator
Z2.Jug
7
HOW TO SET THE CLOCK
When the coffee machine is connected up to the
domestic power supply for the first time the figures
“0:00” will flash on the display (N):
To set the time of day, proceed as follows:
1. Press the
HOUR key for around 2 seconds until
the number of hours on the display increases:
2. Before the display stops flashing (after about 5
seconds), set the desired time by repeatedly
pressing the
HOUR key (fig. 2). Remember to
choose “AM” or “PM” as appropriate:
3. Set the minutes by repeatedly pressing the MIN
key. (The process can be speeded up by keeping
your finger pressed down on the key.)
4. After 5 seconds, the display will stop flashing and
the clock will start to work.
If you need to reset the time, press the
HOUR key for
about 2 seconds, then set the new time, as described
from point 1 down.
The time set will not be held in the memory in the
event of a temporary power cut.
HOW TO SET THE DELAYED START (TIMER)
Check that the time of day has been set correctly.
To set the delayed start (the time when you want to
make the coffee), proceed as follows:
1. Press the
AUTO key for about 2 seconds until
“0:00” flashes on the display;
2. Before the display stops flashing (after about 5
seconds) set the desired time by repeatedly
pressing the HOUR key.