Filter
Top Products
ELECTRICAL REQUIREMENTS (UK ONLY)
Before using this appliance ensure that the voltage indicated on the product corre-
sponds with the main voltage in your home, if you are in any doubt about your sup-
ply contact your local electricity company.
The flexible mains lead is supplied connected to
a B.S. 1363 fused plug having a fuse of 13 amp
capacity.Should this plug not fit the socket outlets in
your home, it should be cut off and replaced with
a suitable plug, following the procedure outlined
below.
Note: Such a plug cannot be used for any other
appliance and should therefore be properly dis-
posed of, (having removed the fuse) and not left
where children might find it and plug it into a sup-
ply socket - with the obvious consequent danger.
N.B. We recommend the use of good quality
plugs and wall sockets that can be switched off
when the machine is not in use.
IMPORTANT: the wires in the mains lead fitted
to this appliance are coloured in accordance
with the following code:
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
symbol or coloured green or green and yel-
low.
The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
When wiring the plug, ensure that all strands of
wire are securely retained in each terminal. Do
not forget to tighten the mains lead clamp on the
plug. If your electricity supply point has only two
pin socket outlets, or if you are in doubt, consult
a qualified electrician.
Should the mains lead ever require replacement,
it is essential that this operation be carried out by
a qualified electrician and should only be
replaced with a flexible cord of the same size.
If the plug is a moulded-on type the fuse cover must
be refitted. If the fuse cover is lost, the plug must not
be used until a replacement cover is obtained. The
colour of the correct replacement fuse cover is that of
the coloured insert in the base of the fuse recess or
elsewhere on the plug. Always state this colour when
ordering a replacement fuse cover.
Only 13amp replacement fuses which are ASTA
approved to B.S. 1362 should be fitted.
This appliance conforms to the Norms EN
55014 regarding the suppression of radio inter-
ference.
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
WARNING - THIS APPLIANCE MUST BE EARTHED
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown to
Live
Cord Clamp